3
GA02329_002_03 - 01/2010 - © Oerlikon Leybold Vacuum
Important Safety Information
Indicates procedures that must be strictly observed to prevent hazards to
persons.
Indicates procedures that must be strictly observed to prevent damage to, or
destruction of the product.
Emphasizes additional application information and other useful information
provided within these Operating Instructions.
The Oerlikon Leybold Vacuum Sogevac
®
SV40 BI has been designed
for safe and efficient operation when used properly and in accordance
with these Operating Instructions. It is the responsibility of the user to
carefully read and strictly observe all safety precautions described in
this section and throughout the Operating Instructions. The Sogevac
®
SV40 BI must only be operated indoor in the proper condition and
under the conditions described in the Operating Instructions. If not,
the protection provided by the equipment may be impaired. It must be
operated and maintained by trained personnel only. Consult local, state,
and national agencies regarding specific requirements and regulations.
Address any further safety, operation and/or maintenance questions to
our nearest office.
Failure to observe the following precautions could result in serious
personal injury!
Sogevac
®
pumps are not designed:
■
for pumping of dusty, aggressive, corrosive, flammable or explosive gases or
gases mixtures,
■
for pumping of oxygen or other highly reactive gases with a greater
concentration than atmospheric concentration (>20%),
■
for working in flammable, explosive or dusty environment.
For all these cases, special materials must be used. In case of doubt, please
contact Oerlikon Leybold Vacuum.
See also the limits of use indicated in the CE declaration of conformity.
Never expose part of the body to the vacuum. There is a danger of injury.
Never operate the pump with an open and thus accessible inlet. Vacuum
connections as well as oil filling and oil draining openings must not be open
during operation of the pump.
When operating pump is hot and some surfaces could reach a temperature
higher than 80 °C (176 °F). There is a risk of burn by touching.
Depending on the process involved, dangerous substances and oil may
escape from the pump. Take the necessary safety precautions !
Disconnect the unit from the power supply before starting any work.
Pump must not be operated above 2000 m sea level.
Safety Information
Warning
Caution
Note
Warning
Warning
