background image

                       Odyssey

®

 Xtreem  

                                                 Single Soil Moisture Logger 

             

User Manual

Intellectual Properties

Bluetooth

®

 is a registered trademark owned by Bluetooth SIG Inc.

Odyssey

®

 is a registered trademark of Dataflow System Limited.

Legal Information

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 

1.

This device may not cause harmful interference, and 

2.

this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the 
following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement

This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and 
operated with a minimum distance of 20cm between the radiator and your body.

Japan (MIC)

The Xtreem loggers are approved for use in the Japanese market.
In Japan, certification is valid for 80 channels between 2402...2481 MHz

CE Warning

This device has been tested for compliance with the relevant standards for the EU market.
A copy of the Declaration of Conformity is available upon request to the manufacturer.
Dataflow Systems, PO Box 13672, Christchurch 8023, New Zealand

Radiation Exposure Information

This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated 
with a minimum distance of 20cm between the radiator and your body. 

Industry Canada

This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions:

1.

This device may not cause harmful interference, and

2.

 this device must accept any interference received, including interference that may cause undesired operation.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the 
transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be chosen so that the 
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.

Radiation Exposure Statement

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20cm between the radiator and your body. 

DATAFLOW SYSTEMS LTD

Page 10

www.Odysseydatarecording.com

 

            V 03/21

Summary of Contents for Xtreem











Reviews: