console)
Your PC (for serial console)
Hardware components required to mount the 2060 (included):
4 threaded hex standoffs (4–40 x ¾”)
4 screws (4–40 x 3/16”)
4 internal star lock washers (#4)
4 nuts (4–40)
Refer to the 2060 CPU Card component diagram, figure 2–1 on page 20, for the
location of various connectors, and to the mounting hole diagram, figure 2–3 on
page 22, for mounting the 2060 CPU Card.
Hardware mounting
1. Use the standoffs, washers, and screws and place them in the four holes on the
2060 board. Refer to Figure 2–3 for the center-to-center mounting hole
dimensions and for the location of the designated holes used for mounting the
hardware.
WARNING!
All four standoffs, screws and washers must be used to secure the
2060. The standoffs ensure full support of the board.
WARNING!
Verify that the washers and standoffs do not touch any of the
component pads adjacent to the mounting holes. Damage will occur
at power-up.
2. Connect a 5V power source to the 2060. Refer to the Power Supply
Requirements section, page 30. The power supply connector is located at J3.
Refer to Figure 2–6 and Table 2–5.
WARNING!
Make sure the power supply is OFF when connecting the power
cable to the 2060 CPU Card board. Damage to the 2060 CPU Card
may occur if the power is ON when connecting the power cable.
Note
The +12V and –12V signals are routed to the PC/104 bus only.
Note
See Appendix A – Connectors for additional mating information.
WARNING!
Accidentally crossing the wires, i.e., pl5V wires into the
ground connector or the ground wires into the +5V connector will
damage the 2060.
29
