Chapter 3: Setup programs
This chapter discusses running the Setup configuration program on the 2060 CPU
Card. Setup configures devices set up by the BIOS such as serial ports, floppy
drives, etc.
Operating systems other than DOS
If you are using an operating system other than DOS the X jumper should be
removed. The X jumper maps the INT17 extended BIOS into the 0xD8000-
0xDFFFF memory. This can cause problems with applications or hardware running
on other operating systems if they attempt to use this memory range. Removing
the X jumper frees this memory for use by other operating systems.
Setup
Setup can be entered by pressing the “F2” key during the BIOS POST sequence
(this occurs between the memory test and boot).
Also, by removing the “S” jumper W1[1–2], you will force the setup to revert to the
factory programmed defaults shown in the following menus. This allows the user
to reconfigure the setup.
Note
The Setup defaults might vary slightly from those shown in the following menus
depending on the BIOS revision on your card.
The system will display the 2060 CPU Card PhoenixBIOS Setup Utility Main
menu. Select the submenu by using the up/down arrows, then press <ENTER>
(when using a monitor connected to the 2060 CPU Card). For a serial console
configuration, Ctrl + E is up and Ctrl + X is down.
36
