75
Ocmis Irrigazione S.p.A. – INSTRUCTION AND WARNING MANUAL – Translation of Original Instructions
MUMR-R1.02 .EN - 31/07/2015
CHAPTER 7 - Maintenance
Any spare parts must be original (under pain of forfeiting the warranty).
Non original spare parts may affect proper operation of the machine and limit its service life and/or performance.
7.2
PERSONNEL IN CHARGE OF MAINTENANCE
Specifi cally, the maintenance operator must:
•
Have knowledge of the directives in force in the country of use relating to the prevention of accidents during work carried out on machines, and
be able to apply them.
•
This Instruction and warning manual and the documentation listed in chapter 9 have been read and understood in their entirety.
•
Be able to correctly use and reference the technical design documentation, including machine diagrams, components manuals, bills of materials,
mechanical drawings, fl uid power schematics, etc.
•
Perform the operations under their responsibility (Mechanics, Oil Hydraulics, etc.) for which they are authorised to intervene.
•
Be able to use the most appropriate troubleshooting instrumentation and know the most suitable equipment for maintenance operations.
CAUTION
Only duly instructed personnel may perform maintenance, adjustment and set-up operations.
CAUTION
Setting the machine in work conditions with disabled protection devices requires adequate skills and knowledge and the utmost
attention by the maintenance technician. It is generally forbidden unless required by special conditions which cannot be avoided.
In this case the utmost attention must be paid.
CAUTION
Should a malfunction or fault be detected during normal operation on assemblies or equipment, you are required to stop the
machine and immediately alert the maintenance personnel and/or support centre.
7.3
GENERAL SAFETY PRECAUTIONS
The personnel in charge of machine maintenance must be well trained and have thorough knowledge of accident protection rules. Unauthorised
personnel must remain outside the maintenance/work area during operations.
The safety precautions set out in this paragraph must always be strictly complied with during machine maintenance, in order to avoid injuries to
personnel and damage to the equipment.
The personnel using the machine and especially those in charge of its maintenance must be aware of the risks arising from the use of hose reel
travelling rainguns.
7.3.1
DANGER NOTES
Below is a series of danger notes to be taken into account during maintenance operations.
They indicate a danger with even fatal injury hazard for the person.
DANGER
In the event it should be required to disable guards and safety devices in order to carry out certain maintenance operations,
remember that:
In such an event the operating personnel are exposed to dangerous conditions, hence the following rules must be strictly
adhered to:
The personnel in charge of performing maintenance activities must be authorised and suitably trained on safety and operational
procedures to be followed, on dangerous situations that may arise and the correct methods to prevent them and the provisions
in force at the site of installation of the country where the machine is installed and used.
During these operations, the personnel must in any event work by paying the utmost attention and operate with the utmost
caution.
DANGER
Prior to performing inspections for any maintenance operations and/or carry out maintenance as described in this manual,
maximum static stability should be assured to the machine by placing it on
a fl at and appropriately fi rm surface able to
withstand its weight; this in order to avoid sudden movements and/or overturning, which may create a hazardous situation to
any maintenance operator. Prior to performing maintenance operations that are not set out and described in this manual, it is
essential to contact the Manufacturer's support service.
Summary of Contents for MR
Page 99: ......
