68
Ocmis Irrigazione S.p.A. – INSTRUCTION AND WARNING MANUAL – Translation of Original Instructions
MUMR-R1.02 .EN - 31/07/2015
CHAPTER 6 - Use and Operation
6.6
STARTING WORK
1) Push the ratchet lever into the HITCHING position.
2) Gradually let water
fl ow in the machine's inlet pipe and wait for the whole system to reach the proper operating pressure. To ensure that, just check
the reading of the pressure gauge located on the machine's water inlet.
CAUTION
If water delivery is interrupted by the pumping station, the machine stops. As soon as it is restored, the machine automatically
resumes operation. As a precautionary measure, it is then recommended to check proper operation of set functions again.
3) Move the gearbox lever to the WORK position (see ref. 47 par.2.5.1), after which the machine starts reeling the hose in and irrigating the fi eld.
CAUTION
To change the number of turbine RPMs:
•
refer to the specifi c manual if the machine is equipped with a computer
•
if the machine is not fi tted with computer move the knob described below in this page.
CAUTION
Should the machine be put in neutral either willingly or unwillingly while the hose is being dragged, the reel might violently turn
in the opposite direction. It is therefore essential to pay the utmost attention in ensuring no people are near the machine.
6.6.1
ADJUSTMENT OF AUTOMATIC SPEED CORRECTION
If the machine is equipped with the optional computer, the computer maintains a constant speed. (standard only for R1AT15 ).
For MR if the machine is not equipped with computer, in order to optimise hose retrieval speed you must act on the by-pass. This is done by manually
loosening the screw inserted in the knob and moving to the left (+ to increase speed) or right (- to decrease speed) then lock again by manually
tightening the knob.
MR
For MR/1 if the machine is not equipped with a computer, in order to optimise hose retrieval speed you must act on the by-pass. This is done by
manually loosening the screw inserted in the knob and moving to the left (+ to increase speed) or right (- to decrease speed) the bush welded on the
telescopic rod, then lock again by manually tightening the knob.
MR/1
For MRR if the machine is not equipped with a computer, in order to optimise hose retrieval speed you must act on the by-pass. This is done by
manually loosening the screw inserted in the knob and moving to the left (+ to increase speed) or right (- to decrease speed) the bush welded on the
telescopic rod, then lock again by manually tightening the knob.
MRR
Summary of Contents for MR
Page 99: ......