EXPLORE
E7
2 0 1 9 I N S T A L L & O P E R A T I O N M A N U A L
13
3.5 CONTROL SYSTEM INSTALLATION
3.5.1 Switch Control
Additional Tools needed that are not supplied by OceanLED
Push switch (Normally Open).
To use Switch Control, the Control Input Cable and Terminator Kit is needed.
To connect the lights to enable control of all lights using a single switch, Explore E6 & E7 Control Link Cables
must be used. The quantity of Control Link Cables per installation is equal to the number of lights minus 1
(Example: If 10 lights are used, 9 control link cables are needed). Please consult the Explore E7 Light Choice
Diagram in section 6.3 for details.
Ensure power is disconnected before attempting to connect or solder any wire.
1. Connect/solder one end of the switch to the red wire (Switch) of the Control Cable and the other end to the
black (Ground), yellow (DMX +) and brown (DMX -).
2. Plug the Switch cable to the Control In Connector of first light.
3. Using the Control Link Cable, connect the Control Out of the first light to Control In of the next light. Repeat until
all the lights are connected. Check the diagram below for clarification.
4. Plug the Terminator to the Control Out of the last light.
Control Link Cable
Control Link Cable
Switch
12/24V DC Power
12/24V DC Power
12/24V DC Power
Terminator
