Oce VarioPrint 4110, User Manual

Page: 185 / 216

185
Instructions for safe use
■
Paper module: at the back of the module, at the right-hand side of the place where
the mains cable enters the machine.
■
Stacker/stapler: at the back of the module, at the right-hand side of the place
where the mains cable enters the machine.
■
Stacker: at the back of the module, at the right-hand side of the place where the
mains cable enters the machine.
■
Finisher: at the back of the module, at the right-hand side of the place where the
mains cable enters the machine.
If connection to a different mains voltage is required, contact Océ Customer
Service.
[103]
[103] Location of the power marking label
Mains connection cable
The machine is connected to the mains by multiple detachable mains connection
cables. Do not use other mains connection cables than the cables that are supplied
with the machine. When replacement of a mains connection cable is necessary
because of damage or defect, contact Océ Customer Service for proper replacement.
Service power point
The operator can access the input interface module at the front of the machine. That
module contains a power point that is intended for service purposes only. Do not
connect any electrical device to this power point.
LCD display
Do not rub, press or touch the display surface with hard material, because the
polarizer at the surface can be easily scratched. The LCD module consists of glass.
Therefore, dropping, pinching strongly or punching can damage the LCD module.
When glass breaks, be careful that you do not to get injured by glass pieces. Call Océ
Customer Service.
USB / RJ45 connection
The USB / RJ45 connection at the left-hand side of the machine is intended for
service purposes only. Do not connect any USB or RJ45 device to this connection.
Otherwise, serious performance problems and an adverse effect on the operation of
your machine can occur.