Oce VarioPrint 4110, User Manual

Page: 208 / 216

208 Appendix A Safety data sheets
Safety data sheets
Material safety data sheet of the Océ toner - Continued
[121]
The content of this safety data sheet is subject to the disclaimer of liability on the
introduction page of this chapter. You can find the translations of the disclaimer in
the Safety data sheets section of the respective languages in this multilingual Safety
information.
Océ F3/F11Toner
SAFETY DATA SHEET
Number EN-262-b-NL
22 September 2008 Date
Page 2/4 Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II
Personal precautions Avoid breathing dust. Refer to protective measures listed in sections 7 and 8.
6. Accidental release measures
:
Environmental precautions Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers. :
Vacuum or sweep up spilled material with a damp rag. Avoid formation of dust. : Spill
Note: see section 8 for personal protective equipment and section 13 for waste disposal.
Handling
Handling and storage
Storage
7.
Handle and open container with care. Avoid formation of dust. See information supplied on the label of the
tonerbottle and in the operator manual of the copier/printer.
Use with adequate ventilation. See operator manual or safety data sheet of the copier/printer.
Keep container tightly closed and sealed until ready for use. Store in accordance with local regulations. :
:
Specific uses
: Keep container tightly closed to prevent dust formation. Handle with care. Avoid breathing dust.
Occupational exposure limits
8. Exposure controls/personal protection
Carbon black ACGIH TLV (United States, 1/2008).
TWA: 3.5 mg/m³ 8 hour(s).
Respirable particulate ACGIH TLV (United States).
TWA: 3 mg/m³
Inhalable particulate ACGIH TLV (United States).
TWA: 10 mg/m³
Recommended monitoring
procedures Not required.
Hand protection
Not required in normal use.
Not required.
Not required. Eye protection
Respiratory protection
Not required. Wash skin with soap and cold water.
Environmental exposure controls Not required in normal use.
Exposure controls
:
:
:
Skin protection :
:
: Use with adequate ventilation. See operator manual or safety data sheet of the copier/printer. Occupational exposure controls
:
Ingredient name Occupational exposure limits
Physical and chemical properties 9.
Solid. [Powder.]
Faint odour. Odour
pH
Black. Colour
Not applicable.
:
:
:
:
Boiling point : Not applicable.
Physical state
Solubility Insoluble in water.
Flash point Not available.
Lower: 60 g/cm 3
Explosion limits
:
Viscosity Not available. :
:
:
Density approx. 1000 kg/m
3
(bulk density). :
Vapour pressure
: Not applicable.
Octanol/water partition coefficient : Not available.
Evaporation rate
:
Not applicable.
Not available. Oxidising properties :
Vapour density
:
Not available.
approx. 50°C (softening point) : Melting point