Oce P2T, Operation Manual

Page: 44 / 62

Turn off the side-trimmer at the mains ON/OFF switch. Wait for 5 seconds and then turn on the
side-trimmer.
Does the problem persist?
Yes No
¦
V No further action is required.
Call your service engineer.
Trimming problem - the book is not trimmed to the correct size
Is the [SIDE TRIM] setting turned on?
Yes No
¦
V Turn on the system
Is the correct trim size entered in the touchscreen? Make sure the size is at least 2mm less than
the book size.
Yes No
¦
V Enter the correct size in the touchscreen.
Open the top cover of the Two-side Trimmer. Wait for the side-trimmer to reset. Does the prob-
lem persist?
Yes No
¦
V No further action is required.
Turn off the side-trimmer at the mains ON/OFF switch. Wait for 5 seconds and then turn on the
side-trimmer. Does the problem persist?
Yes No
¦
V No further action is required.
Call your service engineer.
Side-trimming problem - the book is only trimmed on one side
This problem is normally caused by incorrect set-up. If the side-trim offset is slightly too large,
only one side is trimmed.
The [SIDE TRIM] is completely turned off.
No Yes
¦ Set the [SIDE TRIM] setting to landscape.
¦ Does the problem persist?
¦
Yes No
¦ ¦ No further action is required. 4
Quality problems
44 Chapter 6 - Error Conditions, Problems and Solutions