Oce P2T, Operation Manual

Page: 10 / 62

Your guide
This operation guide describes how to do these tasks.
• Operate the P2T 2-Knife Trimmer
• Find and correct error conditions
• Perform normal maintenance tasks
Operator training is given when the Booklet maker is installed. To make sure you use your
Booklet maker correctly, read your manual.
This operation guide does not describe the operation of the booklet maker. If needed, refer to
your printer user manual.
In this manual the ‘P2T 2-Knife Trimmer’ is referred to as the ‘side-trimmer’.
Safety Information
Safety information is included in the separate “Safety Information Manual.”
Read the safety information before you use your Booklet maker.
Warning and Caution
The warning and caution messages used in this manual are shown below.
WARNING
A CAUTION message tells you that a procedure or operation can be dangerous. To prevent
injury, you must follow the instructions.
CAUTION
A CAUTION message tells you that a procedure or operation can be dangerous. To prevent
damage, you must follow the instructions.
Installation
Your Booklet maker must be installed by a service engineer. Special knowledge is needed to
install the machine.
CAUTION
Connect the machine only to a power supply of the correct voltage with a good ground
connection. The correct machine voltage is shown on the label at the power supply input on the
rear of the machine. If the machine is connected to the wrong supply, the warranty is voided.
How to Get Help
If you have any questions or problems, refer to the problem solving section in this manual ( Error
Conditions, Problems and Solutions on page 41
). Contact your supplier for further information.
10 Chapter 2 - Introduction to the P2T 2-Knife Trimmer