35
Introduction
For your basic operation
Maintenance
When encountering a problem
Appendix
7
Wiping unit side
Capping unit side
With pressing the media edge
guard’s your side part, move each
media edge guard.
Move the media edge guards to each side.
Move the media edge guards to each side so that they
are not under the media.
With pressing the media edge guard’s your side part,
move each media edge guard.
8
Take-up side
Pressure control knobs
Set the pressure to “Open” by rotating the
pressure control knob.
9
Paper feeder
Printer rear
Insert the media end into the paper feeder,
while smoothing out the media by hand to prevent
wrinkles.
If the media is curled
- If it is hard to insert the media end into the
paper feeder due to a curl of the media,
interpose an interleaf and insert the media
end under the interleaf as shown in the fi gure
below.
Inter
leaf
Inter
leaf
Media
Media
- Upward curl
- Downward curl
10
Blip
Feed media for 1m more after the blip.
♪
Platen
Feed the media for 1m more after the blip.
In this state, smooth out the media toward the both
sides on the platen to make the media center tense.
Point to be checked
- If the media is set with a distortion or wrinkles,
it may cause a media jam or skew.