Oce CS 5070, User Manual

Page: 62 / 139

62 Océ CS 5050/5070 User Manual
because it changes the appearance of colours, it is recommended to run a small
test print.
▼
▼ ▼
▼
To apply ink reduction
1
Press
Setup/Ink Option/Ink Reduction
.
2
Choose a reduction percentage -
12.5, 25%, 37.5, or 50%
.
3
Press
OK
.
Selecting ink preheat
Although cartridge heat settings are optimised for Océ media for printing in a
standard office environment, they can vary depending on the ambient
temperature where the printer is located and the type of ink or media used.
Adjusting the ink preheat settings (after applying other corrective measures)
can help solve problems with banding, poor fills, or over dot gain.
The default ink preheat values depend on the type of ink used, which the printer
reads from the chip at the back of each cartridge. You can either increase or
decrease the temperature from the default value by pressing (+) or (-)
respectively. When you reach the limits of the temperature range, the panel
displays
MAX
or
OFF
. The printer saves the new settings, which you must
modify when changing to another type of ink.
Use the following tips to select preheat settings:
■
Turn down the heat for a smaller dot size in a hot or humid environment.
■
Turn up the heat in a cold or dry environment for a larger dot size. However,
too high a setting can cause the ink to run or sputter.
Note:
Adjusting the preheat settings will influence the printed colours.
▼ ▼ ▼ ▼
To select an ink preheat setting
1
Press
Setup/Ink Option/Ink Preheat
.
2
Choose a preheat setting.
3
Press
OK
.