Oce CS 5070, User Manual

Page: 22 / 139

22 Océ CS 5050/5070 User Manual
3
Since media cores can be narrower than the media, position the media guide at
3 mm (1/8”) from the end of the core and lock it into place.
4
Press
Feed Media
/
Forward
to advance enough media to allow its leading edge
to come to the centre of the take-up roll.
[4] Locking the take-up roll
5
Using at least three pieces of tape, attach the leading edge of the media to the
take-up roll at the left, right, and centre of the core.
6
As printing progresses, the media loops down to the front of the take-up core
until the sensor detects it on the printer stand leg. The take-up rolls then
activate to roll the media.
Note:
Be sure not to block the sensor!
[5] Sensors on the printer stand
▼ ▼ ▼ ▼
To set the take-up mode
1
Press
Setup
/
Paper Option
, then
Supply Type
/
Take-up
.
2
Press
OK
. This enables the take-up roll and disables the cutter.