87
Lubricate the Stitch Head
Before You Begin
[52]
Apply the Grease to the Driver Bar
[53]
Step
Action
Information
1.
Trim the first part from the nozzle.
2.
Remove the cap from the tube of grease.
3.
Fit the nozzle to the tube of grease.
4.
On the user interface, touch
ADVANCED > STITCHER UP >
STITCHER UP
The folder cover must be
closed. This action moves the
stitch head to the correct
position for lubrication.
5.
Lift the BLM500 main deck
See Lift the Océ BLM500 Main
Deck
Step
Action
Information
1
Use the supplied air duster to
remove dust from the stitch head.
2
Remove the wire holder from the
stitch head.
Move the wire holder retaining spring
to the right. Then remove the wire
holderIntroduction
3
Apply a small amount of grease
to the visible surface of the driver
bar
[47]
[48]
4
Re-fit the wire holder.
30mm
Summary of Contents for BLM 500
