Oce BLM 500, User Manual

Page: 54 / 106

54 Chapter 5 Error Conditions, Problems and Solutions
Error Messages
MOTOR
OVERLOAD The drive motor controller has
reached its power limit. Check
for a paper jam and clear if
necessary. If the problem
continues, contact your service
engineer.
REMOVE SET
FROM FOLD AREA Open the folder cover and
remove the set.
REMOVE SET -
GATHERING AREA Open the gathering area and
remove the sheets. Or touch
'PURGE SET'.
Rotate axis moving The rotate axis is moving. This
message clears when the
adjustment is complete.
Shuttle axis moving The shuttle axis is moving. This
message clears when the
adjustment is complete.
SHUTTLE MOTOR
COMMS FAIL Use the mains ON/OFF switch.
Turn the machine OFF, then turn
the machine ON. If the problem
continues, then call your service
engineer.
SHUTTLE MOTOR
ERROR Use the mains ON/OFF switch.
Turn the machine OFF, then turn
the machine ON. If the problem
continues, then call your service
engineer.
SHUTTLE NOT
PARKED The shuttle is in the wrong
position. Touch START
to
reset the position.
Sidelay axis moving The sidelay axis (size
adjustment) is adjusting. This
message clears when the
adjustment is complete.
STACKER FULL The stacker is full. Unload the
books from the stacker.
Stitch axis moving The stitch axis is moving. This
message clears when the
adjustment is complete.
Problem Cause Solution