27
The BASIC Window
- NUMBER
Touch NUMBER to select how many times the form
roller processes the spine. The available options are 1, 2,
3 or 4. The form function can be turned off. An increase
in NUMBER increases the time taken to form the spine
and can decrease the production rate for thin books.
Alternatively, increase the PRESSURE.
- PRESSURE
Touch PRESSURE to increase or decrease the pressure
used to form the spine. Touch + to increase the amount of
spine form. Touch - to decrease the amount of spine form.
The range is -9 to +9. The default setting is 0.
- THRESHOLD
The square spine is formed only on sets thicker than
0.8mm. To change this value, touch THRESHOLD and
enter the value you need. The maximum value is 1.5mm.
TRIM
The trim dimension is calculated automatically
according to the PAPER SIZE and SET THICKNESS.
If needed, the trim dimension can be changed. Touch
TRIM to adjust the size of the finished book after the
fore-edge is trimmed. The maximum trim is 30mm. The
trim function can be turned off.
[10] The BASIC Window Buttons
(2 – 2)
Button
Information
Summary of Contents for BLM 500
