Oce BLM 500, User Manual

Page: 31 / 106

31
The CONFIGURE Window
The CONFIGURE Window
Introduction
The CONFIGURE window lets you make changes to the configuration of the
machine.
Some of the settings can be changed, depending on the current access level.
CONFIGURE Window Buttons
[13]
[13] Button overview
Button Information
MACHINE
OPTIONS Touch MACHINE OPTIONS to view the general
machine setup. Some of the settings can be changed,
depending on the current access level.
- MEASUREMENT Select 'mm' or 'inch' as the unit of measurement.
- STITCH SENSOR There is a sensor that checks for stitches. Touch STITCH
SENSOR to turn the stitch sensor on or off. The default
setting is ON.
- PRESET PAPER
SIZES The preset paper sizes can be either ISO A sizes or US
paper sizes. To select which preset paper sizes are
available, touch the relevant button.
NETWORK
SETTINGS This button is used by the service engineer.
SHUTTLE Touch SHUTTLE to make adjustments to the tamper
and pickup.
-TAMPER DELAY The tamper removes air from the set before the set moves
to the stitch area.
Touch TAMPER DELAY to increase or decrease the
delay before the tamper is activated. Light weight paper
may need more time to stabilize.
An increase in TAMPER DELAY causes a decrease in
the production rate for thin books.
The default setting is 400.
- TAMPER TIME TAMPER TIME adjusts the time that the tamper
touches the set. The default setting is 600.
FORM This button is used by the service engineer.