28
4700 Series Scanners Installation Manual
4730 model
1
Insert the Height Alignment Chart into the scanner and press
Paper Feed
.
2
In Power Scan, select a Scan Width of 8.5 and press
Forward
to prescan.
3
When the horizontal lines have been prescanned press
Halt
.
4
Set the
Detail
window from the center of the
Overview
window so that you can
view the lines clearly.
The
Detail
window should resemble one of the three as below.
5
Use a small screwdriver to turn the screw through the hole on the front of the
scanner body (see figure 14) either clockwise or anti-clockwise until the
horizontal line is a continuous line:
Clockwise:
Line on the right side of the screen moves down.
Anti-clockwise:
Line on the right side of the screen moves up.
[15] Checking Camera Alignment
4740 model
1
To adjust the left camera (seen from front of scanner), follow same procedure
as for the 4730 model, but select a
Detail
window centered about one-third in
from the left of the
Overview
window. Use the screwdriver through the left
hole.
2
To adjust the right camera, follow the above procedure, but select a
Detail
window centered about one-third in from the right of the
Overview
window.
Use the screwdriver through the right hole.
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38
HEIGHT ALIGNMENT CHART
PART NO. 6399A102
INSERT THIS EDGE AT
0
INSERT THE TEST CHART
WITH THIS SIDE DOWN
INSERT THIS EDGE
Summary of Contents for 4700 Series
