24
SECTION 4: USING THE OSD MENUS
Display settings
2.
Move the cursor to the target item and click
IRIS+
and click up/down direction buttons to choose each display mode as ON
or OFF, and define each display time as 2 seconds, 5 seconds or 10 seconds.
3.
Click
IRIS+
button to confirm your selection.
NOTE
If you enable both ZOOM and PT OSD while calling a preset, the preset label will be displayed until the preset finishes.
Display the viewing direction
The camera displays a viewing direction code when you manually rotate the camera. Codes are shown in the table below.
Display
N
NE
E
SE
S
SW
W
NW
Indication
North
Northeast
East
Southeast
South
Southwest
West
Northwest
4.2.5 IR parameter configuration
You can configure the IR parameters including the IR sensitivity, n/m LED current, reference height, reference zoom, and LED control,
fan control, switch delay, heat control, and IR correction, etc.
1.
Open the IR PARAMETER submenu. Go to
MAIN MENU
g
DOME SETTINGS
g
SYS INFO SETTINGS
g
IR PARAMETER
