Objet Eden350, User Manual

Page: 82 / 130

Operating & Maintaining the Eden 3-D Printer
7–6
DOC-00500 Rev. F
Printing
Indicators
When the printer is ready, the main interface screen changes (see
figure 7 ‐ 5):
•
The mode changes from Pre ‐ print to Printing .
•
The specific activity being performed is shown in the “current activity”
field.
•
Current job ‐ printing information is displayed.
•
The printing progress bar is displayed.
•
The Stop and Pause buttons are enabled.
Figure 7-5: Eden printer interface during printing
When printing begins, Job Manager sends seven slices to the Eden printer.
This is the standard buffer between the Job Manager and the printer. As
each slice is printed, the Job Manager sends another slice to the printer.
Depending on the size of the model(s) to be produced, printing can take
between several hours to several days. As long as there is enough model
and support material in the supply cartridges, printing proceeds
automatically until the job is finished.
Resuming Production After Printing has Stopped
If the printing process is interrupted for any reason, Job Manager stops
sending slices to the Eden printer.
To continue printing the model:
1. Switch the printer to online mode by clicking the red button at the
bottom of the Eden printer interface (see figure 7 ‐ 3 on page 3).
The button changes from red to green (see figure 7 ‐ 4 on page 5).
Current Activity
Job information
Progress bar
Pause button Stop button
Printer mode
Job information
During printing, the server computer must remain on and it must
communicate with the Eden printer. Do not log-off Windows until printing is
finished.