CX Logix Operation MANUAL
– Updated July 2022
Page 3 of 15
1.
IMPORTANT WARNINGS & SAFETY INSTRUCTIONS
Important Warnings
This manual contains important information about the installation, operation, and safe use of this product.
This information should be given to the owner and/or operator of this equipment. When installing and
using this electrical equipment, basic safety precautions should always be followed. Failure to follow
safety warnings and instructions in this manual can result in serious injury and/or damage to your
equipment. Read and follow all warning notices and instructions which are included in this manual.
•
The pH controller case contains live components internally. There is a danger of electric shock if
opened. If the power cord is damaged then it should be replaced by the manufacturer, their agent or
similar qualified person, to avoid a hazard.
•
The product shall be installed by a qualified person in accordance with AS/NZS 3000 wiring rules.
•
The pH controller should be installed in the correct pool zone and connected to supply via a power
outlet that is protected by a residual current device (RCD) having a rated residual operating current
not exceeding 30mA. The power outlet should have a degree of protection suitable for the pool zone.
•
To reduce the risk of injury, do not permit people (including children) with lack of experience and
knowledge, to use this appliance unless they have been given supervision or instruction concerning
use of the appliance.
•
To reduce the risk of accidents or incidents, service on the unit should only be performed by a
qualified pool service professional, after disconnecting it from the mains power supply.
•
During the installation check the following:
o
that the injector point pressure is lower than 150kPa (to ensure optimum flow)
o
that the peristaltic pump’s acrylic front cover is correctly fitted
o
that the suction tube is securely fitted in the acid container, with weight touching the bottom
and the drum label is fitted on the outside of the container
o
that the suction tube is fitted to the left side and the injector tube to the right
o
that the injector valve o’ring is fitted between the valve and the CLEAR faucet tee and the
BLACK lock nut is securely fastened
Important Safety Instructions
When mixing acid with water, ALWAYS ADD ACID TO WATER. NEVER ADD WATER TO ACID.
Always wear the appropriate safety equipment specified by the acid supplier when handling acid.
The system uses a 1 : 3 Acid : Water mix ratio (e.g. with a 20 litre drum add 15 litres water then
5 litres acid). It is important to use this mix for the correct acid volume to be added.
DO NOT
PLUG UNIT IN IF CARTON HAS BEEN WET.
When using the CX Logix:
•
Observe all applicable local, state, and federal safety regulations.
•
Take proper precautions with prescribed environmental and operational conditions.
•
Consider chemical compatibility with all wetted materials.
Summary of Contents for CX Logix
Page 1: ......
