- F -
Protect the plug connection from moisture. Install the power pack at a flood protected place and provide a minimum
spacing of 2 m from the pond edge. Protect the connection cable when burying to avoid damage. Only use cables
approved for outside use. Only operate the unit when plugged into an earthed socket. The latter must have been
installed in accordance with the valid national regulations. Ensure that the protective earth wire is led to the unit. Never
use installations, adapters, extension or connection cables without protective earth contact! Ensure that the unit is
supplied via a fault current protection (FI or RCD) with a reference fault current of 30 mA maximum. Ensure that the
power connection cable cross section is not smaller than that of the rubber sheath with the identification H05RN-F.
Extension cables must meet DIN VDE 0620. Only use unwound cables. Electrical installations in garden ponds and
swimming ponds must meet the national and international regulations valid for installers. Compare the electrical data of
the supply with those on the unit type plate. This data must coincide.
Never operate the unit if the cable or housing are defective! Disconnect the power! Do not carry or pull the unit by the
connection cable.
Only use the unit with the attendant safety transformer contained in our scope of delivery. Never open the unit housing
or its attendant components, unless this is explicitly mentioned in the operating instructions. Always disconnect the
power supply of all units located in water and of this unit prior to performing work on the unit! For your own safety,
consult a qualified electrician if you have questions or encounter problems!
Set-up and start-up
The unit is supplied fully assembled as a complete set containing a power pack and three LED spotlights. When set up
above the water level, maintain a safety distance of at least 50 cm from combustible material. Ensure a safe seating.
Do not cover the unit. Danger of fire!
Position the unit such that it does not present a hazard for anybody. As an option, you can bolt the foot on a firm
ground or a load bearing wall (A1). Adjust the light tilt and arrest this angle with the screw connection (A2).
Connect the plug of the spot light power cable to the transformer socket. Plug the transformer power cable in the mains
socket. Check the spotlight function.
The LED light cannot be dimmed. The brightness of an LED reduces as the operating time increases.
Cleaning
Adhere to the safety instructions! Only use water and a soft brush. Ensure that no moisture can enter the unit.
Repair
Neither the power pack nor the LED spotlight can be repaired in the event of damage to the cables or the housing and
have to be replaced. For your own safety, consult a qualified electrician or your specialist dealer if you have questions
or encounter problems!
Storage
Clean the unit and check for damage. Store at a place inaccessible to children.
Disposal
Dispose of the unit in accordance with the national legal regulations.
S
Malfunctions
Malfunction Cause
Remedy
Lamp does not light up
Power supply interrupted
Check power supply
Light intensity decreases
Lamp glass soiled
Clean
- F -
Remarques concernant cette notice d’emploi
Avant la première utilisation, lire attentivement cette notice d'emploi et se familiariser avec l'appareil. Respecter impé-
rativement les indications de sécurité relatives à une utilisation correcte et en toute sécurité.
Utilisation conforme à la finalité
Le projecteur LED Luminis 3, dénommé par la suite «appareil», est réservé pour une utilisation avec des installations à
jet d'eau et des bassins, et pour une température de l'eau allant de +4°C à +35°C, ainsi qu'une profondeur d'immersion
jusqu'à 4 mètres. Le bloc d'alimentation électrique ne doit être utilisé qu'à une température ambiante comprise entre -
10°C et 40°C.
Utilisation non conforme à la finalité
En cas d'utilisation non conforme à la finalité et de manipulation non appropriée de cet appareil, des risques pour les
personnes peuvent en résulter. Toute utilisation non conforme à la finalité entraîne l'annulation de notre responsabilité
ainsi que de l'autorisation d'exploitation générale.
7
