Tools required: 17mm wrench
Step 2: Assemble Front Leg
5
1.
Remove all parts from height adjuster threaded
axle assembly.
2.
Insert the 20mm pin into the inner front leg hole
with the thread aligned vertically.
3.
Screw the threaded flange into and
through the threaded pin by about 25mm/1”.
Add M16 washer.
4.
Loosen the clamping knob.
Align the clamping plate square in the
slot as the outer front leg slides over
the inner leg.
5.
Slide the outer leg down until
the axle protrudes through the top
plate.
6.
Thread the M10 half nut and
knob onto the top of the height
adjuster thread.
7.
While holding the knob, tighten
the nut with the 17mm wrench up
against the knob to secure in position.