Pre-set
Positions
HAND CONTROL OPERATIONS •
C
elesta
G
emini
™
Position 5:
-
full horizontal position
Position 6:
- Reclined with leg rest
at low incline
Position 8:
- upright position with leg
rest at mid-incline
Position 7:
- slight recline
with leg rest
at low incline
5
6
7
8
C
elesta
G
emini
™
Do not leave clients
unattended when table
is set at its highest level.
Close supervision is necessary
when this unit is used by or
near, children, invalids or
disabled persons.
Press and hold the appropriate button until the position desired is
achieved and then release. The arm rests will adjust automatically to
provide the most in comfort and ergonomics while staying parallel
to the floor, no matter what the position.
• Hand Control
CAUTION
When operating the
C
elesta
G
emini
™
controls and
making any and all adjust-
ments to the table, move
hands and feet away from
the working mechanism of
the table.
Children must always be
supervised when around this
equipment by a responsible
adult. Do not leave children
alone or allow them to operate
the controls. Do not allow
children to crawl into the
cabinet or under the table.
CAUTION
DO NOT
use the hand
control and the foot control
simultaneously as this can
cause damage to one or
both units.
8
DIRECTIONS FOR USE
• Adjusting Height and Top Positions
of the
C
elesta
G
emini
™
using the Hand Control
DIRECTIONS FOR USE
IMPORTANT
13
DIRECTIONS FOR USE
• QuickLock
™
Face Rest
DIRECTIONS FOR USE
Double articulating action provides nearly limitless positioning options
with the QuickLock
™
Face Rest.The adjustable pad takes pressure off
sensitive facial areas while providing superb support. The QuickLock
™
Face Rest can be used in both prone and supine positioning and folds
out of the way when not in use. Adjustments are made easily by loosening
the cam locks, adjusting for height and angle and then locking the cam
locks into that position. The
C
elesta
G
emini
™
has webbing loops at the
head of the table for a variety of uses and outlets at the other end that
work as well for additional procedures.
Attaching the QuickLock
™
Face Rest / Head End Webbing:
When attaching the QuickLock
™
Face Rest, just slide the frame dowels
into the webbing loops, being sure to keep the 1st cam lock within 3" of the
table to ensure a stable connection. The recommended length of dowel
bracing against the backrest should be at least 2 inches.
To remove the QuickLock
™
Face Rest, just pull the frame from the webbing
loops until it comes free. Set it safely aside or store it inside the under-
table cabinet until needed.
Do Not
extend the dowels of
the Face Rest further than 3"
from the table edge to ensure
a stable connection.
* U.S. Patent #5,177,823
CAUTION
CAUTION
Do not put excessive weight
or pressure on the face rest.
Excessive pressure can cause
premature failure of the
QuickLock
™
Face Rest.
QuickLock
™
Face Rest
Important Safety Note: Maximum
Distance from edge of table = 3"
3"
2"
Be sure to read all
cautions, warnings
and instructions given
in the manual to prevent
injury to both operator
and client.
QuickLock
™
FACE REST:
• Accessory Option:
QuickLock
™
Face Rest
DIRECTIONS FOR USE
IMPORTANT
IMPORTANT
