4
INST
ALLA
TION
INSTALLATION
INSTALLATION
• Leveling Instructions
The
C
elesta
G
emini
™
comes completely assembled and ready to use. Plug the
cord into a functioning outlet that is rated for the table.
Arrange the power cord and control cords so that they will not create a tripping
hazard. Place the controls in a safe location where they are convenient and
accessible. Keep the controls out of the way of all table mechanisms.
L E V E L I N G I N S T R U C T I O N S :
If Table Will Not Sit Flat on the Floor:
The
C
elesta
G
emini
™
is equipped with Leveler Feet that adjust to level
the table on uneven floors. To adjust the Leveler Feet to suit common
floor differences you will need to use a
1
/
2
" open-end wrench or an
adjustable wrench. Adjust each leg individually in turn by adjusting the
height of each leveler foot until the unit rests level and steady. This
adjustment will not effect the function of the table.
1/2" Open-end Wrench
Leveler Foot
CAUTION
The table weighs as much
as 300 lbs.
DO NOT
lift or
move the unit without using
proper safely procedures
or equipment.
DO NOT
turn
the
C
elesta
G
emini
™
on its side
for any reason. To do so
could cause damage to the
base and
will
void the warran-
ty. There are no serviceable
items that require this action.
Never lift the table by grasp-
ing the table top as the
table top is not designed to
hold the weight of the base
and you could damage the
table.
IMPORTANT
• Leveling Feet
When operating the
C
elesta
G
emini
™
controls be
sure to observe all cautions
and warnings given in the
manual to prevent injury to
both operator and client.
4. To access the control box to disconnect the hand control you must first
remove the control box mounting bracket from the underside of
the cabinet (head end) by unscrewing the four knobs that hold the
bracket in place. Brace the bottom of the control box with one hand
while loosening the knobs. Once the knobs are removed, rest the
control box carefully down on the floor. There is plenty of excess cord
stored inside the cabinet to allow the control box to sit on the floor
and to rotate the mounting plate to face you.
5. Follow the coil cord for the hand control back to the place
where it connects to the control box. Press down on the cord
connector tab and unplug the hand control.
6. Pull on the hand control’s coil cord enough to enable you to
reach the plastic cord restraint that holds the cords in place (the
black foot control cord enters the control box here as well).
Remove the plastic cord restraint by just applying a little pressure
to one side. Slide the hand control cord out of the slit in the restraint.
Discard the inoperable control.
17
TROUBLESHOOTING
• Hand Control Replacement Instructions
TROUBLESHOOTING
TROUBLESHOOTING
• Hand Control
(cont)
(back of
control box)