16
TROUBLESHOOTING
• If
C
elesta
G
emini
™
will not Change Height or Position
• Hand Control Replacement
TROUBLESHOOTING
I
F THE
C
ELESTA
G
EMINI
™
WILL NOT CHANGE HEIGHT OR POSITION
:
• Check the outlet to be sure that it has power and that the power
cable is plugged in. Try each Foot Control and Hand Control to
see if any work. If any work, then possibly there is a loose connection
or a faulty controller.
• Unplug the power cable from the wall outlet.
• Make sure that all male and female connectors are firmly
pushed into each other. Even a slight misconnection can
cause a possible malfunction.
• Plug the unit back into the wall and check the controls
again. If one or more of the controls still do not work,
contact Customer Service at 800-558-8850 to arrange
replacement. After receiving replacement for the needed
control then proceed to the section describing the replacement
of the inoperative control.
HAND CONTROL REPLACEMENT INSTRUCTIONS
Replacement of the Hand Control may be necessary if the Hand
Control does not actuate the functions of height adjustment or
table top positioning.
To Replace the Hand Control, follow these steps:
1. Obtain the
new
Hand Control. (see Parts List, pg. 27)
2. It is recommended that the table be raised to a high height level
(use foot control) if possible, as you will need to drop the
control box out from beneath the cabinet. You will need about
14" of space to work easily.
3. After raising the table, disconnect the table’s power cord from
your power outlet before proceeding.
TROUBLESHOOTING
CAUTION
The table weighs as much
as 300 lbs.
DO NOT
lift or
move the unit without using
proper safety procedures
or equipment.
DO NOT
turn
the
C
elesta
G
emini
™
on its side
for any reason. To do so
could cause damage to the
base and
will
void the warran-
ty. There are no serviceable
items that require this action.
Never lift the table by grasp-
ing the table top as the
table top is not designed to
hold the weight of the base
and you could damage the
table.
IMPORTANT
NOTE:
The new electronic
component will be
reinstalled in the same
manner as the old one.
When dissembling please
take note of the order,
installation method and
placement of plugs as
the new unit will be
reassembled in the
same way.
CAUTION
Before doing any work on the
unit,disconnect the power
cord from the power outlet.
Be sure to read all
cautions, warnings
and instructions given
in the manual to prevent
injury to both operator
and client.
• Controls
ADJUSTING HEIGHT OF THE TABLE:
The O
AKWORKS
®
C
elesta
G
emini
™
comes complete with a multifunctional
hand control that operates the height, backrest and leg rest positioning
functions as well as a foot control that operates the height with
electronic ease. These controls should not be used simultaneously
but individually to ensure safety and complete ease of use.
Foot Controls:
Operate the foot control as shown below to raise or lower the height
of the
C
elesta
G
emini
™
. The foot control allows the therapist to adjust
the height function separately from the other functions found on the hand-
control whenever needed. When operating the table’s controls, be sure to
observe all cautions and warnings as given in the manual.
Hand Control: 10 positioning Buttons
The Hand Control on the
C
elesta
G
emini
™
operates all the positioning and tilt
functions available at the touch of a button. The top 4 buttons operate
the customizable positioning of the backrest, seat and leg rest of the
top while the next 2 buttons operate the height of the table. The lower
4 buttons activate the pre-set positions of the Access Design flex top.
Follow the directions on the next two pages to access these functions.
5
DIRECTIONS FOR USE
• Adjusting Height and T ilt Angle
of the
C
elesta
G
emini
™
using the Foot Control
DIRECTIONS FOR USE
Foot Control (1):
(used only to change height of table)
UP
DOWN
C
elesta
G
emini
™
When operating the
C
elesta
G
emini
™
controls be
sure to observe all cautions
and warnings given in the
manual to prevent injury to
both operator and client.
CAUTIONS
When operating the
C
elesta
G
emini
™
controls and
making any and all adjustments
to the table, move hands, feet
and controls away from any
working mechanisms of the
table.
Children must be supervised
when around this equipment by
a responsible adult. Do not
leave children alone or allow
them to operate the controls.
Do not allow children to crawl
into the cabinet or under the
table.
DIRECTIONS FOR USE
• Foot Control
CAUTION
DO NOT
use the hand
control and the foot control
simultaneously as this can
cause damage to one or
both units.
IMPORTANT
