3
PRODUCT DESCRIPTION
•
C
elesta
G
emini
™
PRODUCT DESCRIPTION
Ta b l e S p e c s * :
• Height *:
25" - 37"
• Width:
31"
• Length:
72"
• Lift Capacity:
625 lbs Maximum Working Load
• Weight:
300 lbs.
• Top:
Electronically Controlled
Easy Access Design Top
• Electronics:
1 Hand Control & 1 Foot Control
• Padding:
Aero·Cel
™
System
• Upholstery:
Ultratouch II or TerraTouch
™
• Cabinetry:
Wood/ Maple
For electrical specs, see Specifications Chart, pg 24.
* measurements are determined from floor to top of seat pad using
standard padding; these measurements can be affected by natural
material variations in padding
** published weight may differ due to options chosen, natural
material variations and padding density
C
elesta
G
emini
™
-
Model GMCTMP
Self Adjusting
Removable
Ar m Rests (2)
Hand
Control (1)
Sliding Cabinet
doors (2 - access
both sides)
Upholstered
Top
Access
Design Top
Back Rest
Fully Enclosed
Cabinet Base
- Maple
Accessory
Outlets (2)
Foot Control (1)
Vertical
Electronic
Lift Columns (4)
Leg Rest
Seat
Adjustable
Interior
Cabinet
shelf; foot
end only (1)
PRODUCT
DESCRIPTION
IMPORTANT
7. Take the new hand control and thread the straight section of cord
closest to the plug into the slit of the plastic cord restraint. The
cords for both the hand control and the foot control will fit in to
this slit. Place the plastic cord restraint into the hole in the bottom
plate of the control box bracket and push it into place using
slight pressure until the cord restraint flange is flush against the
control box bracket.
8. Plug the new hand control into the control box bracket at the
same connection where the inoperable unit had been.
9. Carefully lift the control box, mounting bracket and excess cords
back up into the cabinet floor, being careful to keep all of the
excess cordage out of the way of the control box opening. Be sure
all cords are away from the screw area of the knob connections.
Line up the screw holes, hold the control box bracket base plate
in position and begin to fasten the knobs onto the 4 screws.
Hand tighten them until the bracket is secure.
10. Connect the power cord and test the new hand control.
Should you need assistance at any time, please call a Customer Service
Representative at 800-558-8850.
TROUBLESHOOTING
Be careful of slack in the
power cords as you put the
junction box back into the
cabinet.
18
TROUBLESHOOTING
• Hand Control Replacement Instructions
TROUBLESHOOTING
CAUTION
• Hand Control
(cont)
