To display a list of the devices registered to a specific manager, type the command “get_manager” followed by the ID of the
manager obtained previously.
SHELL>> get_manager 2
SHELL>> ManagerID-2. DeviceID 0 DeviceName - OASIS_3D
Figure 74. Inference engine and oasis version commands
More information on Framework managers and HAL devices can be found in the Software Developer’s Guide.
6.12 Print version information
To quickly identify the features supported by the application, it is necessary to know which version of the Smart Lock application
is currently running on the kit. Use the “version” command to display the version of the application currently running on your kit.
This command also prints the current application bank being used by the running application. This is useful when performing
Mass Storage Device drag and drop flashing to determine which type of binary to provide to the kit. For more information on Mass
Storage Device drag and drop flashing, see the SLN-VIZN3D-IOT Software Developer’s Guide.
SHELL>> version
App running in bankA
Version 1.1.0
Figure 75. "version" command
Alternatively, the “version oasis” command identifies the version of the Oasis Lite library running on your kit.
SHELL>> version oasis
Oasis version 1.23.0
Figure 76. “version oasis” command
6.13 Reset the SLN-VIZN3D-IOT
Some situations may require restarting the kit without physically power cycling the kit or pressing the reset button. This is possible
using the “reset” command, which performs a soft reset of the kit, going through the entire boot process again.
SHELL>> reset
System will reset
Figure 77. Soft reset command
After any reset of the SLN-VIZN3D-IOT kit, you may need to restart any computer application used to control or
communicate with the board (for example, Serial Terminal for USB to Serial Commands, Camera application for
UVC mode.).
NOTE
NXP Semiconductors
Additional features
SLN-VIZN3D-IOT Kit User Guide, Rev. 0, 01 November 2021
User Guide
41 / 47
