Board Interface Connector
MPC5777C EVB User Guide, Rev. 1
39
NXP Semiconductors
Figure 28:
SIPI Interface connections
The connector used in the daughter card and its mating Zipwire cable is detailed in
Table 237: Connector and its mating Cable Details
S.No
Connector/Cable
Manufacturer
Manufacturer Part Number
1
Connector
on the Daughter card
SAMTEC
ERF8-005-05.0-L-DV-L-TR
2
Zipwire Cable Assembly
NXP
SIPI-ERM8-ZIPCBL
Reference:
For more information about the ZIP wire Interface is available at
Application Note AN5134 “Introduction to the Zipwire Interface”.
CAUTION
Zipwire is intended to be used between two devices on the same printed
circuit board. This connector and cable is only intended for evaluation of
products and not for actual customer implementations.
5.10
MCU Interfaces with Mother Board
The Signals interfaces from the MCU are connected with High Density connecter which connects
with Mother Board for user access. Following interfaces can be access in the Mother Board
through 0.1inch pitch 18-pin Headers,
•
ADC channels
•
Enhanced Modular IO Subsystem (eMIOS)
•
Enhanced Time Processing Unit (eTPU)
•
Deserial Serial Peripheral Interface (DSPI)
5.11
Test points
—
516 Daughter Card
MPC5777C-516DS Daughter card test points are listed and detailed in
