Distributor of NXP Semiconductors: Excellent Integrated System Limited
Datasheet of MPC8569E-MDS-PB - BOARD MOD DEV SYSTEM MPC8569
Contact us: [email protected] Website: www.integrated-circuit.com
MPC8569E-MDS-PB Hardware Getting Started, Rev. 3.1
32
Freescale Semiconductor
Getting Started Procedures
Procedure 7: Perform initial board power-up and check LEDs (Section 7-8).
CAUTION!
Prevent damage to the USB TAP; connect only after initial board reset.
1. Power PB via an external 5V power supply; LED D6 glows yellow.
2. Press SW2 to Power-ON all PB components.
3. Check for completion of PRESET sequence; indicated by steady lights from LEDs D1, D2 or D3, and D12.
4. Press SW2 to Power-OFF all PB components.
Procedure 8: Connect CodeWarrior USB TAP to the PB.
CAUTION!
To avoid damage, follow steps for
aligning and connecting the Bootwiz.
NOTE!
Freescale’s CodeWarrior USB TAP
enables CodeWarrior IDE software
to work with the PB.
1. Align Bootwiz module with its CS
facing the board’s printed “COP”
text. The PS must face switches
SW5 - SW10.
2. Connect the Bootwiz module to the
J13 COP board connector.
3. Attach the USB-TAP cable to the
Bootwiz module’s J2 connector.
4. Press button SW2 to Power-ON all
PB components.
5. Check for completion of the reset
sequence.
Procedure 9: Attach cables per user development needs and planned board use.
1. Connect FSL adaptor cable to J21
on PB.
2. Connect RS-232 (male) cable to
COM1/2 (UART0/1) of FSL adaptor
cable.
3. Connect RS-232 (female) to a PC.
4. Connect GETH loopback (shown in
picture) or ETH cables with RJ45
connectors to the Ethernet ports:
– J14 for GETH1
– J6 for GETH2
5. Continue as per CodeWarrior Kit
Configuration Guide instructions.
SW2
J13
Bootwiz CS
PS
Bootwiz CS
GETH Loopbacks
J6
J14
J21
FSL Adaptor
(with COM1/2)
RS-232
(male)
33 / 39
33 / 39
