Page 12
Triac Model Operating Instructions (continued)
Note:
The run timers for each component are independent of each other. At
the end of the cycle, the component will automatically turn off.
Configuration #6 (Continued)
The LED Multi-Color Tub Light is activated by pressing the Light button. The first
press will start its 30-
minute timer, and activate the Tub Light in a “Rainbow”
mode. Subsequent presses will change the color to Blue, White, Blue, Aqua, Green,
Yellow, Red, Magenta, and off. The Tub Light will turn off automatically when the
timer expires. To turn off this function earlier, press and hold the Light Key at any
time.
Configuration #7
—
Tri Speed Pump
w/ Oscillation Option (No Light)
The Whirlpool Water system is activated by pressing the “Water”
Air Button. This will turn on the load at high speed and activate the
automatic 30-minute timer. Subsequent presses will change the
speed to medium, low, oscillate mode and off. The system will
stop automatically when the timer expires.
Configuration #8
—
Variable Speed Pump
w/ Oscillation Option (No Light)
The Whirlpool Water system is activated by pressing the “Water”
Air Button. This will turn on the Blower at high speed and activate
its 30-minute timer. Press again to turn off.
To reduce speed, Press and Hold to ramp down and release at desired speed. A
Subsequent Press-and-Hold resets the load to High Speed and Ramp Down
sequence. The Oscillate feature is activated if the button is held for 2 seconds after
reaching the “Low” speed in the speed ramp. The system will stop automatically
when the timer expires.
Configuration #9
—
Tri Speed Blower
w/ Oscillation Option (No Light)
The Air System is activated by pressing the “Air” Air Button. The Air
System runs independently of the Tub Water Level. This will turn
the Blower on at high speed and activate its 30-minute timer.
Subsequent presses will change the speed to medium, low,
oscillate mode and off. The system will stop automatically when the timer expires.
