15
EN
TECHNICAL OWNER MANUAL
3.7 Installing Shift Cables and Hardware
Install cable end hardware only by pulling
cables at the end of the housing (
A
). Never
rotate the grip (
B
) with cables unattached, as
they can bind inside the shifter.
1.
Pass the shift cables through the
appropriate cable housing and ensure
the housing is seated completely into the
shifter.
•
Thread both barrel adjusters completely
clockwise (in) to provide maximum
installation slack.
2.
Pull the underdrive shift cable (
C
) firmly
at the rear axle location until it stops,
checking to make sure that the shift
indicator (
D
) goes completely flat (
Nfinity
C8
and
Nfinity
C8s
shifters), or that the
grip rotates fully in the counter-clockwise
direction shown (
Nfinity
C3
shifter, viewed
from right side of bicycle).
3.
Pass the underdrive shift cable through the
UD cable stop (
F
) and secure the UD cable
stop at the distance shown (
E
) while pulling
the cable firmly.
•
Ensure that the cable housing is seated fully
at the shifter.
•
Using a 2mm allen, secure the cable and
torque to 1.5-2.0 Nm (13-18 in-lbs).
NFINITY
ASSEMBLY OF COMPONENTS
4.
Cut the excess cable at a maximum of
2.0mm from the end of the UD cable stop
(
G
).
5.
Pull the overdrive shift cable (
H
) firmly
at the
Nfinity
Hub Interface until it stops,
checking to make sure that the shift
indicator (
I
) goes into a steep hill (
Nfinity
C8
and
Nfinity C8s
shifters), or that the
grip rotates fully in the clockwise direction
shown (
Nfinity C3
shifter, viewed from
right side of bicycle).
•
Make sure the underdrive shift cable and
UD cable stop are free and unobstructed
6.
Pass the overdrive shift cable through the
OD Latch (
K
) and secure the OD latch at
the distance shown (
J
) while pulling the
cable firmly.
•
Ensure that the cable housing is seated fully
at the shifter.
•
Using a 2mm allen, secure the cable and
torque to 1.5-2.0 Nm (13-18 in-lbs).
7.
Cut the excess cable at the OD latch
marking (
L
), and tuck the remaining cable
length into the OD latch as shown (
M
).
8.
The cable hardware should appear as
shown. Assemble to CVP per
section 2.5
and adjust cable slack with the barrel
adjusters per
section 2.3.
E
C
B
F
G
A
D
120 mm
H
I
J
L
K
M
114 mm
