ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
Hardware Used
2
2. Attach three support brackets loosely to base with
three bolts
M8 x 16 (BB)
downward through support
brackets into the Base.
BB
Bolt M8 x 16
x 3
BB
3
3. Install post onto three support brackets. Attach
post to support brackets using six
bolts M6 x 30
& six
M6
flange nuts. Fully tighten all of the screws.
CC
x 6
M6 Flange nut
EE
Bolt M6 x 30
x 6
Hardware Used
EE
CC
Hardware Used
AA
BB
1. Attach wheel assembly (I) to base (H). Line up holes
in wheel bracket with corresponding holes in base, insert
two bolts
M8 x 16 (BB)
through holes, and finger tighten
two M8 flange nuts (AA)
. Be sure that the wheel assembly
is parallel to the base, and fully tighten bolts.
x 2
Bolt M8 x 16
M8 Flange nut
x 2
1
H
AA
BB
I
B
DD
FF
GG
Hardware Used
DD
5
x 4
Stainless Steel Bolt
5. Attach reflector spacers (FF) and Ø8 washers(GG) to
the top of head assembly (B). Tighten the reflector
spacers (FF).
Unscrew stainless steel bolts (DD) from head
assembly (B).
6
GG
x 3
FF
x 3
Reflector spacer
Hardware Used
DD
x 4
Stainless Steel Bolt
6. Insert hose of head assembly (B) into post (F). Secure
head assembly (B) to post (F) with stainless steel
bolts (DD).
Note: The control knob on head assembly (B) should
be above the decal on post (F).
4. Load Cylinder Housing onto Post.
Slide Cylinder Housing down.
4
