Nussbaum UNI-LIFT 5000 CLT PLUS, Operating Instruction And Documentation

Page: 24 / 56

Operating Instruction and Documentation
UNI-LIFT 5000 CLT / Plus
- 24 -
• Move the Dip-switch 5 on position „on“.
• Press the button „reset“ (1) and hold it.
• Switch-off the main switch and wait 5 sec. Hold the reset button.
• Switch-on the main switch and wait 5 sec. Hold the reset button.
• Let go off the reset button.
• Press the button „lowering“ until the lift (both platforms) is in the lowest position
and the acoustic signal stops beeping.
• Move the Dip-switch 7 on position „on“.
• Dip-switch 5 stays on „on“ position.
• Press the button „reset“ (1) and hold it.
• Switch-off the main switch and wait 5 sec. Hold the reset button.
• Switch-on the main switch and wait 5 sec. Hold the reset button.
• Let go off the reset button.
• Dip-switch 5 stays in „on“ position.
• Move the Dip-switch 7 on position „off“.
• On the computer-board must now three diodes lighten permanently. One additional
diode must be blinking in the frequency of approx. 1 sec.
• Raise and lower the automotive lift a few times without load. Observe the process.
• Mount the cover.
6.2 Emergency lowering of the main lift/ wheel free lift
A emergency lowering is an intervention into the control of the lift and can be
done only by experienced expert.
The emergency lowering must be carried in this order. Otherwise a malfunction
can lead it to damages or lead to danger for body and lives.
Every kind of external leakage must be removed. This is necessary particular
before an emergency lowering.
pic.3: hydraulic bloc