Nussbaum HF 3S 12000, Operating Manual

Page: 12 / 64

12 OPI-POWER LIFT HF 3S 12000-V1.0-EN
2 System master sheet
2.1 Manufacturer
Otto Nussbaum GmbH & Co. KG
Korker Straße 24
D-77694 Kehl-Bodersweier
2.2 Purpose
The lift is a lifting tool for raising motor vehicles in normal workshop operation. A total weight of max. 12000 lbs
(5000 kg). Single loading of the carrier arm may not occur.
Set up of the standard lift in explosion endangered workshops and humid spaces (e.g. washing halls) is
prohibited. This is only possible with custom equipment.
Lift operation is done directly on the operating column.
After construction and maintenance changes on load carrying parts the lift must be inspected afterwards
by a specialist who approves the changes. If the set up location is changed, the lift must be checked
again by a specialist and changed approved.
Carrier arm variants POWER LIFT HF 3S 12000
Double swivel arm (DG) max. 1825 mm
2.3 Changes to the design / construction
Inspections by a technical expert are required before recommissioning (date, type of change, technical
expert signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________ _________________________________________________
Location, date Technical expert signature
2.4 Changing the assembly location
Inspections by a technical expert are required before recommissioning (date, type of change, specialist
signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________ _________________________________________________
Location, date Signature of Technical Expert of Safety inspections