Nussbaum 2.30 SPL, Operating Instruction And Documentation

Page: 18 / 42

Operating Instruction and Documentation
2.30 SPL
- 18 -
The emergency-lowering can only carry out, if the ratchets are not locked.
• Press the button „ Lifting “ until the ratchets are free.
• Remove the cover of the safety ratchets.
• Pull back the ratchets manually and fix it with suitable object (example: wire).
• Check the dangerous places of the lift and be sure that there are no objects or people in the
immediate area of the lift or on the lift.
• Pull the lever slowly down. The lowering process starts.
• Observe the complete process.
• Lower the lift in the lowest position.
• After the emergency lowering, the lift must shut down until the defective parts has been
changed.
7. Inspection and Maintenance
Before conducting maintenance work, preparations must be made to ensure that
during maintenance and repair work there is no risk to the safety of people working
on or around the lift and also that there is no risk of damage to equipment being used
on or around the lift.
To guarantee the utmost availability and to ensure that the lift remains functional, maintenance
work contracts are organised between our clients and their local retailers.
A service must be performed at regular intervals of 3 months through the operator in
accordance with following service manual. If the lift is in continuous operation or in a dirty
environment, the maintenance rate must be increased.
During daily operation the lift must be closely observed to ensure that it is functioning correctly.
In the case of malfunction or leakage the technical service must be informed.
7.1 Maintenance plan of the lift
• Before beginning any maintenance work isolate the power supply. Secure the main switch
(lock it). Secure the danger area around the automotive lift and secure the lift against
unintentional lowering.
• Clean the piston-rod using compressed air.
• Check the condition of ropes. If torn wires are discovered, the complete rope-set must be
changed.
• Grease the piston rods with a high capacity lipid (approx. 5 g of S2 DIN51503 KE2G
available from the Renolit Company.
• Grease the lubricate nipples with a multipurpose lipid. (example: Auto Top 2000 LTD. Agip).
• Clean and lubricate the moving parts of the lift (hinge bolts, sliding pieces, sliding surfaces)
grease with a multipurpose lipid (example: Auto Top 2000 LTD. Agip).
• Check the hydraulic tubes for leakage.
• Check the oil level. Fill the tank with a clean, high quality oil (32 cst) (e.g.g. HLP 32 LTD.
OEST Company)