Numatic TTV 678-300, Operator'S Instruction Manual, Page: 24 / 72

24 235670 10/11 (A07)
Setting the operator pre-set buttons
& % ' %
Brush pressure / Load adjustment
Settings can be stored using one of the three pre-set store buttons (S1/S2/S3).
];=&;<';;><;
;'<&‘
your settings are now saved.
This facility can be re-set as often as you wish by simply following the steps above.
S1 S2 S3
CS
Cleaning Speed setting (CS). When this button is activated the speed is restricted to
3.5km/hr maximum even with the accelerator pedal fully depressed.
This is ideal for long cleaning periods.
Once this pre-set button is switched-off, the machine will operate at up to a maximum
speed of 7.0km/hr.
When the waste water-tank becomes full, a red warning light will illuminate on the
operator control panel (as illustrated) and the vacuum motor will stop automatically
after 5 seconds.
The waste-water tank requires emptying (see page 30).
The machine is equipped with a brush-pressure load-warning system.
Y';;<';‚;
manually by the operator using the adjuster knob found on the left hand side of the
control column.
Turn it anti-clockwise to decrease load on the brushes and clockwise to increase
;{'"="JJ>"
NOTE: The run-time of the machine may decrease
if the load on the brushes is increased
Fig.33
Machine Set Up / Einrichtung der Maschine/ Fonctionnement de la machine / De machine gebruiken