NTI VOPEX SERIES SPLITTER/EXTENDER
9
PLUG-IN AND BOOT UP
1.
Plug the power cord from each video device and the power supply for each audio device into a power outlet.
2.
Connect the
5VDC 3A
power connector to the power port on the VOPEX (shown in Fig. 1- Page 5).
3.
Connect a
9VDC
1A
AC
adapter to each XTENDEX Remote Unit. Make sure the power connectors go into each port
all the way.
4. Plug each AC adapter into a power outlet. The green LEDs on the VOPEX and the RJ45 connector of each XTENDEX
Receiver should illuminate, indicating that a proper power connection has been made to them. (See Fig. 5)
Figure 5- Connect an AC adapter to a 1000 Foot Remote Unit
5. Turn ON the audio and video source(s), stereo speakers, and monitors. They should react as if they were
directly connected to each other.
Note: The yellow LED on the RJ45 connector of each XTENDEX Receiver will blink anytime data traffic is passing
between the VOPEX and the XTENDEX Receivers, indicating proper CAT5 cable connection and communication.
(See Fig. 5)
