NTEK doortalk, Product Manual, Page: 46 / 71

45
STEP 1.6.3 Failed Setup
STEP 2.1
Tap “DoorTalk Tab”
Note:
A pop-up message will appear if the setup was
successful (figure 1.6.2.1 ). Tap OK and wait for
the DoorTalk voice prompt “WiFi connection
successful” (this may take around 30-60 seconds)
followed by the voice prompt “Auto Provisioning
Successful”.
Otherwise, an error message will display on your
mobile device (figure 1.4.5 ).
Instant Troubleshooting:
A failed setup may occur if (1) the DoorTalk
device is not powered up or (2) the Network
SSID “DoorTalk_AP” is not available. In case of
failed setup, check if the LED/Status indicator
of the DoorTalk device is blinking. If not,
check the power source and do a soft reset
by unplugging and replugging the DoorTalk
device. Then, repeat Step 2.4 onwards.
Figure 1.6.3.1
STEP 2: Checking the SIP Profile
Congratulations! DoorTalk device now is already configures
Reminder:
To check your SIP Profile follow
these steps (this information will
help you add clients)
STEP 2.2
Tap “Settings” .
STEP 2.3
Choose “DoorTalk Setup” (Figure 2.3.1)
STEP 2.4
Tap the Refresh button.
Figure 2.3.1