NSS Electro-Mist 4B, Operator'S Manual

Page: 9 / 26

GENERAL INFORMATION AND
WARNINGS
• This NSS machine is delivered with a 12V, 2.5A
battery charger set for 12AH AGM batteries.
• Electronic automatic battery charger with
microprocessor suitable for different battery types.
See Battery charger manual included with this
machine for details.
• Fully automatic charging cycle with electronic set-
tings; protected against overload, short-circuit at
clamps and reversed polarity.
• Before starting to charge, make sure the voltage
of the equipment suits the voltage of the battery,
that the charging current suits the capacity of the
battery and that the selected charging curve (for
lead-acid batteries or sealed batteries) is correct
for the type of battery to be charged. In addition,
make sure the rated input voltage of the charger
suits the available supply voltage and the system
is equipped with grounding.
• Pay attention to any instructions of the battery
manufacturer.
OPERATING PRINCIPAL OF THE
BATTERY CHARGER
When powering up the battery charger it will display
either the flashing Red LED or Green LED for 5 sec -
onds while it checks the AC input voltage and the DC
battery voltage and decide whether or not to start the
charging process.
Flashing Red LED at start up indicates one of the two
WET charging curves.
Flashing Green LED at start up indicates one of the
two AGM/GEL charging curves.
If the battery is not connected to the battery charger
or if there is an anomaly, the Yellow LED will flash. If
the result is positive after 1 second, the charging of
the battery will start with the Red LED on. The output
relay closes and the current of the first phase rises
slowly until the programmed nominal value is reached.
If the user disconnects the battery from the battery
charger during charging, the Red, Yellow and Green
LED’s will be on for 1 second. After that, the battery
charger will reset.
The progress of the charging process is shown by
three LED’s: Red, Yellow and Green as typical for the
battery charger product range. The Green LED indi-
cates the end of the charging or the last phase in the
case of a deep charging process. When charging is
finished, the relay is opened to disconnect.
OPERATION INSTRUCTIONS
• Plug the cord into a socket.
• The charging cycle progress will be shown by Red,
Yellow and Green LED indicators. At the end of the
charge, when the green indicator is on, unplug the
cord from the socket and operate the machine.
Battery Charger Operating Instructions
Front label on Battery Charger SPE CBHD1
Curve SW1 - Dip 1 SW1 - Dip 2 SW2 - Dip 1 SW2 - Dip 2
AGM ON ON ON ON
BATTERY CHARGER CURVE SETTING