9
National Rejectors, Inc. GmbH, Buxtehude
G-13.6 Characteristic features of the system
In case the acceptance rate for a coin or token programmed by teach
mode is not sufficient, you can programme the coin or token with wider
acceptance bandwidths. Therefore please do the following:
•
DIL-switch no. 12 ON. Teach mode is now active.
•
Turn switch for desired channel 10 or 11 ON.
•
Insert new coin or token at least 10 times.
The acceptance gate gives an acoustic signal (1 time). Coin values
are registered.
•
Turn channel no. 10 and 11 ON.
Wide acceptance bandwidths are now calculated.
•
Turn switch no. 12 OFF.
•
Turn switch 10 and 11 OFF.
Coin or token is now programmed. The teach mode has now be
finished and the channel 10 and 11 are enabled.
In case the acceptance gates gives an acoustic signal twice, the
following reasons could be possible:
•
coin could not be programmed. It exist an overlapping of the
acceptance limits with already programmed coins/token.
•
an error has happend during measurement.
•
the programming has been interrupted.
•
the acceptance limits could not be assigned to a channel as switch
no. 10 or 11 was turned ON first instead of switch no. 12.
If a coin or token could not be programmed the existing values remain
stored in any case.
