-
73
-
REASSEMBLY OF THE HAMMER
8. Apply a thin coat of grease on the o-
ring (RR) and push it into the body bore
(
7
) and up against the end of the “B”
sleeve (P).
9. Install the o-ring (RR) into the counter
bores of the grease passage of the
spacer section (J). Seal the o-ring
(RR) into place with a bead of RTV
Silicone.
10. Install the spacer section (J). Align the
dowel pins on the “B” sleeve with dowel
pin holes in the spacer section (J).
Make sure grease passages are
aligned.
11.
Make sure the spacer section (J) is
snug to the body. If the spacer section
(J) is not square to the body, it is
because the sleeves are slightly rotated
out of position. Take a dead blow
hammer (t2) and rap sharply on the
high corner of the spacer section (J).
This will rotate the spacer section (J)
and sleeves into correct position.
