Operating manual
LTSA LTMA
2.
(Optional) Install sub-D cable harness (if not yet done):
a) Remove the motor (1).
b) Replace sub-D cable harness (2).
c) Install the motor.
For further details, see Service manual XLP 51x, chapter “Appendix” > “Internal rewinder / dis-
penser” > “Retrofitting from Basic to Peripheral”.
3.
Screw the stepper motor output stage board to the printer base with the supplied screws (A, 2x
M4x8) as shown.
Edition 02 - 7/2021
19
Commissioning
Installing conversion kit LTMA in XLP 514
