22
EDIt MEnU
The
edit
button allows access to two main functions, depending on how the button is pressed.
Template Edit Mode
Press and RELEASE the
edit
button to enter ‘Template Edit’ Mode. This mode allows you to edit settings that affect
the whole template (e.g. Velocity curves)
Control Edit Mode
Press and HOLD the
edit
button to enter ‘Control Edit’ Mode. This mode allows you to change the settings for each
individual control within the current template (e.g. CC messages)
tEMPLAtE EDIt MEnU
The following settings affect all the controls within the currently loaded template.
Note: All settings must be manually saved by pressing the
write
button.
Pot Pick-up - Pick-Up
This sets how the rotary pots and sliders behave when switching template and can be set to ON or OFF.
ON: After selecting a template, if the current position of a control does not match the value of the control stored with the
template, the control will not have any effect when operated until its position matches the value stored with the template.
OFF: After selecting a template, if the current position of a control does not match the value of the control stored
with the template, the control value will jump from the stored value to match the position of the control as soon as the
control is operated.
Note: Individual controls can have their own Pick-Up settings. The Template setting will be ignored unless the individual
control is set to TEMPLATE.
Template Routing Sub Menu
Although it is possible for the user to edit the Automap Template from the ZeRO SL MkII, editing the following settings for
the Automap Template should NOT be done.
Program Channel, Program Port - ProgChan, ProgPort
These settings define which MIDI Channel and Port the Drum Pads, Control and Expression pedals are sent to.
Common Channel, Common Port - ComnChan, ComnPort
These settings define which MIDI Channel and Port the all Pots, Encoder, Sliders, Buttons and XY pad are sent to.
Both Program and Common settings (above) provide a way of changing the routing of multiple controls from one knob.
For example, in control
edit
options (see final chapter) setting each individual control to Common Channel and Common
Port, rather than a specific Channel and Port, means that to change the Channel and Port of all controls is done via the
routing sub menu (above) rather than editing each individual controls routing.
