34
DRUM PAD notE (DRUMnotE)
This option only applies to the drum pads and allows you to set them up to send MIDI note data when hit. The velocity value
sent is always dependent on how hard you hit the drum pads and cannot be set to a fixed value. The Ports, MidiChan and
Name settings are the same as for Control Change (CC) so see that section for information on these settings.
Note:
This is the same as for ‘NOTE ON/OFF’ so see that section for information on this setting.
Auto-Off:
This sets the amount of time (in milliseconds) that a note off message is sent after the drum pad has been hit.
It can be set to ‘NONE’, in which case a note off message is not sent at all, or from 10ms to 16383ms.
Off Sync:
This sets the timing reference for the note off message that is sent after the drum pad has been hit. It can be
set to ‘TIMER’, in which case the note off message will be transmitted after the number of milliseconds Auto-Off is set to
(or if Auto-Off is set to ‘NONE’ no note off message will be sent at all). The other options allow you to set a note length, in
which case the ZeRO SL MkII will ignore the Auto-Off setting. Instead it uses MIDI clock as a timing reference and sends a
note off message after the selected note length has passed. If you are recording notes into a sequencer then you will need
to make sure that you are sending MIDI clock from the sequencer to the ZeRO SL MkII and that the ZeRO SL MkII is set to
sync to incoming MIDI clock. The range of the note length setting ranges from 32nd triplet to 12 bars. When selecting a
note length, ‘T’ indicates a triplet note length and ‘D’ indicates a dotted note length.
SyStEM REAL tIME (REALtIME)
The Ports and Name settings are the same as for Control Change (CC) so see that section for information on
these settings.
The available options for this setting are standard MIDI system real time messages: start (RT-Start), continue (RT-Contu),
stop (RT-Stop), active sensing (RT-Actvs) and system reset (RT-Reset).
tEMPLAtE
This option is different to the others describe above in that it is not a type of MIDI message. Instead this option allows
you to set any control button, drum pad or the control pedal to switch to another template on the ZeRO SL MkII. No MIDI
message is sent when you operate a Template control.
