![Novatel HS 3001 Integration Manual Download Page 8](http://html.mh-extra.com/html/novatel/hs-3001/hs-3001_integration-manual_1711412008.webp)
- vii -
l
The antenna connected to the Enabler HS 3001 module must be installed to provide at
least 20 cm separation from the human body at all times.
l
The Enabler HS 3001 module and transmitter antennas must not be co-located with any
other transmitter or antenna within a host device.
l
The transmitter antenna used with the Enabler HS 3001 module must not exceed the
following levels:
l
Band Class 0: the maximum gain is 2.2 dBi.
l
Band Class 1: the maximum gain is 8 dBi.
l
To comply with the aspects of KDB996369, strict adherence to the design parameters in
Section 4.1.1.3 Antenna And RF Signal Trace must be observed. Section 4.1.1.3 provides
PCB RF trace design guidelines for the coplanar microstrip between the Enabler HS
3001 RF compression pads and the U.FL style coaxial connector.
l
A label containing the FCC and Industry Canada IDs must be permanently affixed to the
exterior of the host device into which the Enabler HS 3001 module is installed. The label
may also be under a panel or battery pack if it is readily accessible and cannot be
separated from the host device itself. The label must contain a statement similar to the
following;
l
This device contains FCC ID: MIVCNN0301
l
This equipment contains equipment certified under IC: 4160A-CNN0301
If any of these conditions are not met then additional information should be sought from the
FCC or an FCC qualified test laboratory.
If the Enabler HS 3001 module is intended for use in a portable
1
device, the OEM integrator is
responsible to design the product to comply with RF exposure, and must work with Novatel
Wireless (the grantee) to satisfy FCC/IC SAR requirements. Refer to FCC OET Bulletin 65
Supplement C for information about FCC RF exposure compliance requirements for mobile
and portable devices.
The system user manuals and other documentation must clearly indicate operating conditions
that must be observed to ensure compliance with FCC/IC RF exposure guidelines and also
include appropriate caution and warning statements and information.
The host device containing the Enabler HS 3001 module may also require compliance to FCC
Part 15 Subpart B – Unintentional Radiators.
1
Portable Device Definition – FCC defines as a transmitting antenna located at a distance
≤
20cm from the user.
Summary of Contents for HS 3001
