59
Preparing for Configuration
IMS-MN-LMDE42C_A
Liberty MDrive Ethernet TCP/IP
Metal surfaces of the product may exceed 70°C (158°F) during operation.
WARNING
HOT SURFACES
• Avoid unprotected contact with hot surfaces.
• Do not allow flammable or heat-sensitive parts in the immediate vicinity of hot surfaces.
• Verify that the heat dissipation is sufficient by performing a test run under maximum load
conditions.
• Check the temperature during test runs.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
Preparing for Configuration
The following tests are required before configuration:
• The device may be commissioned in system or out of system.
• Only supply voltage
VDC
and the Ethernet interface connections are required for
Configuration.
• Ensure that this chapter is read in it’s entirety, as many setup parameters are mode-specific.
For configuration and programming, a computer with the LSS is required.
NOTE:
Detailed usage instructions and screen captures of the LSS are found in the LSS manual,
which is available for download from:
https://novantaims.com/dloads/
For devices that have CyberSecurity enabled, initial configuration of the device will require
additional setup. Refer to the following website for supporting information and access to Setup
Notes:
https://novantaims.com/all-products/cybersecurity/
Installing the LSS
NOTE:
The Ethernet Interface of the LSS is used for performing firmware upgrades.
• Computer running Windows 7 or greater.
• Internet connection.
• Reference the LSS product manual for installation and configuration information.