Programming Options
36
UDACT Instruction Manual PN 50050:H 09/16/2002
Programming Event Codes (69-208)
The type of reports and 'event codes' that are sent to the Central Station are in Table 4 through Table 9.
The selections made for the Primary Central Station Number Communication Format (address 16) and
the Secondary Central Station Number Communication Format (address 42) automatically program
addresses 69-208 with factory default selections.
Any of the event codes may be changed.
Consult your Central Station prior to altering the event
codes.
For the 3+1, 4+1 and 4+1 Express formats, entering an event code of '0' will cause the
communicator to NOT transmit the report. Enter two zeroes for 4+2 and 4+2 Express Formats. For
Ademco Contact ID format enter three zeroes. Transmission of reports to either or both Central Station
phone numbers may be disabled.
Note the special 'System Abnormal Test Report' event code. This report was added per UL DACT
requirements. This report is generated in place of the normal test report when an alarm and/or trouble
condition exists at the time the test report is due to be sent.
Programming the Real-Time Clock
Entering an address greater than 209 will cause a display of the current time. On power up, the clock
will start running from the factory setting of 00:01 (military time).
The far left digit will be flashing, indicating that this is the first digit to be programmed. Select a digit
then press
ENTER
/
STORE
. The digit 2nd from the left will start flashing. Select a digit then press
ENTER
/
STORE
. Hours setting is complete. With the digit 2nd from the right flashing, select a digit then press
ENTER
/
STORE
. The digit on the far right will start flashing. Select a digit then press
ENTER
/
STORE
.
Minutes setting is complete.
End Programming
Exit Programming Mode by pressing
MODE
, followed by the 4-digit code corresponding to an alternate
mode of operation, then press
ENTER
/
STORE
. For example to return to Normal Mode: Press
MODE
,
6676
,
and
ENTER
/
STORE
. During Program Mode, if no key is pressed within 10 minutes, the UDACT will
revert to Normal Mode.
Technical Manuals Online! - http://www.tech-man.com
