Norton C1320P, Owner'S Manual

Page: 6 / 44

6
1. Before mounting any blade on the saw, the blade should be
inspected for any damage which might have occurred during
shipment, handling or previous use.
2. The blade collars and arbors should be cleaned and examined for
damage before mounting the blade.
3. The blade must be properly fitted over the arbor with the drive pin on
the outside collar projecting through the drive pin hole on the blade
and inside collar.
4. The blade shaft nut, which is a left hand thread nut, must be
tightened securely against the outside blade shaft collar.
5. The blade must be operated within the specified maximum operating
speed listed on the blade.
6. Turn water control valve to full to provide adequate coolant (5 to 8
gallons per minute) for diamond blades and wet cutting abrasive
blades. Insufficient coolant could result in severe blade breakage or
diamond segment separation.
7. The blade guard must be in place with the nose guard down and
locked when the saw is running.
8. The operator should wear safety glasses and any other appropriate
safety equipment.
9. When starting the saw, the operator should stand away and to the
side of the blade.
10. If for any reason the saw should stall in the cut, raise the blade out of
the cut. Check the outside blade shaft collar and nut for tightness.
Inspect the blade for damage before restarting the saw. User caution
when resuming a cut. Be certain that the blade is in alignment with
the previous cut.
11.
During cutting operations, do not exert excess side pressure on the
handles as a method of steering. Do not force the blade into the cut
by lowering the blade too fast or by pushing the saw too fast.
You Are Responsible For Your Safety!!!